Exxis ER0024 CCTV Monitor Operating Manual « on: November 21, 2007, 10:02:24 AM » This post is for Debra or anyone else who has an operating manual for this unit. I have an EXXIS EO4174Q SECURITY MONITOR and an Exxis VHS machine and two cameras with RJ-45 cables. However, I - Answered by a verified Electronics Technician. Houston Security Contractor, Access Control Company, Houston Security Company, IP Camera Company, Alarm Monitoring, Electric Locks, Security Consulting.

Exxis security monitor model EO5214QC » » Page 1 of 1 [4 Posts]:: Author Message captainvideo462002@yahoo. Electronics forum Guru Wannabe Joined: 03 May 2005 Posted: Fri Feb 03, 2006 12:52 pm Post subject: Exxis security monitor model EO5214QC This security monitor has four camera inputs and a built in sequencer.

Neon Genesis Evangelion Shinji Ikari Raising Project Game English. It clicks only and will not power up. The camera cables connect to the monitor with 8 pin RJ45 type modular connectors.

I'm not familiar with this system at all. Is this digital video or composite? Are there any service notes on this unit or is anyone familiar with it? If this is composite then with baluns installed on the cables I should be able to substitute a different monitor and external switcher if the the monitor is unrepairable right?

Thanks for any advice. Lenny Stein, Barlen Electronics. Download Faculty Mentoring Program Evaluation on this page. WB2MEP electronics forum beginner Joined: 22 Jun 2005 Posted: Sat Feb 04, 2006 8:21 am Post subject: Re: Exxis security monitor model EO5214QC wrote: Quote: This security monitor has four camera inputs and a built in sequencer.

It clicks only and will not power up. Sims 3 Baby Changing Table S. The camera cables connect to the monitor with 8 pin RJ45 type modular connectors. I'm not familiar with this system at all. Is this digital video or composite? Are there any service notes on this unit or is anyone familiar with it? If this is composite then with baluns installed on the cables I should be able to substitute a different monitor and external switcher if the the monitor is unrepairable right? Thanks for any advice.

Lenny Stein, Barlen Electronics. Lenny, We have a similar Exxis system in my wife's store that was installed by the previous owner ~ 1996. Not sure if its the same model, but uses the same proprietary cabling and large RJ45 connectors. These cameras output regular composite video, and our camera also had a mic. Don't know if the audio is direct feed from the mic, or line level (preamp in camera). The monitor also provides 15 Vdc to the camera.

(I measured it when I opened the camera to see what was inside.) I would bet that the cable just has a couple thin coaxial lines for video/audio, plus a few unshielded for power, etc. Our monitor also had one of those RJ-45s for the VCR I/O. It used a ribbon cable with 4 RCA plugs on the other end to go to the VCR A/V I/O jacks. The coax lines in that cable were the diameter of a 20 ga. I suspect similar coax is inside the camera cables and just center & shield go straight into the RJ-45s with no baluns needed. Once you figure out the pinouts of the camera cables, you should be able to cut the RJ45s off, wire up some connectors, and a 15 V power supply and use your external switcher. Exxis was pretty worthless as far as support on these.